In GAS FITTER HO GAR we have the technology of ultrasound, which allows you to locate underground filtration to the exterior or interior of your property.

Furthermore, thanks to the experience and the tools used by the GASFITTER HOGAR technicians, we managed to locate water leaks in the most complex scenarios such as departments, construction sites, houses, etc.

If you have a water leak in GASFITTER HOGAR, we carry out the whole process until the client has the desired solution:

  • Detection of water leakage.
  • Demolition and chopping of the area where the water leak is located.
  • Clear surface to later repair the water leak.
  • Repair and change of pipes where the hole is found.
  • Repair damaged and damaged areas by demolition or chopping.
  • Cleaning of the work area.

How to repair a leak in a hot water boiler

Check the drain valve for leaks. The drain valve is the valve that is usually located near the bottom of the tank. Hand tightens the lid if it is leaking. Do not use a wrench, as you could over-tighten the valve.

Remove the old valve if it continues to leak. Use the wrench to remove the lid from the water tank.

Screw the new valve into the water tank by hand. Use the wrench to tighten the lid two turns pass tight by hand. Never tighten again unless it is leaking, as the valve may be damaged.

Check the ventilation tube. If the water heater is gas powered, check the exhaust valve for any obstruction. The vent is located on top of the water heater and is made of sheet metal tubes. Use your hand to remove whatever is obstructing the ventilation grill.

Inspect the pipes for leaks that are connected to your water heater. If the pipes leak, tighten the connection with the key. If stretching the relationship does not work, you must replace the accessory.

Plumbers Midland TX
Address :
5608 Gallop Ct ,Midland , TX 79705
Phone No:(432) 203-4700

Detection and Repair of Water Leaks